Central Pneumatic 92037 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
SKU 92037 For technical questions, please call 1-800-444-3353 Page 5
Assembly
The Air Hammer comes completely assembled, except for any air inlet fittings.
Note: Use pipe thread seal or Teflon tape on all threaded connections.
Air Connection
1. Attach a 1/4” NPT plug (not supplied) into the Air Inlet (9) fitting. A fitting is
necessary before a connection can be made to an Air Compressor.
2. For easy connection or removal, attach an Air Quick Coupler (not supplied)
hose on the compressor.
3. Retighten all couplings and fittings.
Oiler and Filter Connection
Dirt, water, and the lack of pneumatic tool oil are major causes for tool wear. Install
an optional oiler-filter, as illustrated below for better performance.
Connect the air tool, air hoses, filter, and oiler to the Compressor Air Outlet as
illustrated below. The filter and oiler (not supplied) are recommended but not
mandatory for operation.
If the filter and oiler are not used, connect the air hose directly to the 1/4 inch, 18
NPT connector located at the Air Inlet (9) fitting. Also, a few drops of pneumatic
tool oil must be added through the air line before each use.
Operation
Attach Chisel to Air Hammer
1. Remove air supply hose from the Air Hammer.
2. Unscrew the Retainer Spring (15) from the Cylinder (14). Refer to the photo
on the next page.
3. Insert the 10 mm Chisel shank into the Cylinder (14).
4. Screw in the Retainer Spring completely onto the threads of the Cylinder (14)
until it stops, to solidly hold the Chisel in place.
Page view 4
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments