3491 Mission Oaks Blvd. / Camarillo, CA 93011Copyright © 1997 by Harbor Freight Tools®. All rights reserved.No portion of this manual or any artwork
TighteningStep 1: Check the direction of the drive by pressing the TRIGGER (#4) as shown in Figure 3.Step 2: If the Air Ratchet is going clockwise (th
MAINTENANCEYour Air Ratchet is best operated with an Airline Oiler. If you are using the Air Tool without anAirline Oiler, follow the steps below.Ste
Impact Wrench OperationStep 1: Set the compressor’s pressure regulator to a maximum of 90 PSI. 90 PSI is satisfac-tory without harming this tool.Step
Step 6: Select the power setting for Loosening by pushing in and turning the AIR REGULATOR (#11) located on the bottom of the Impact Wrench as show
Step 8: Press the TRIGGER (#4) to test the Impact Wrench. The Impact Wrench should spin freely as shown if Figure 10.Figure 10 — Pressing Trigger
TighteningStep 1: Verify that the power level is correct for your needs and that the REVERSE VALVE(#3) has been shifted (pressed) completely to the le
PARTS LIST – RATCHET WRENCHItem# Parts No. Description Item# Parts No. Description1 HY150-01 Housing 23 HY150-23 Ratchet Yoke2 HY150-02 Connection Hea
Exploded View Diagram - Ratchet WrenchPage #17 -- SKU: 33567 REV 12/02For technical questions, please call 1-800-444-3353.
PARTS LIST – AIR IMPACT WRENCHItem# Parts No. Description Item# Parts No. Description1 16001 Housing 23 16023 Ball Bearing (X2)2 16002 Valve Sleeve 24
Page #19 -- SKU: 33567 REV 12/02Exploded View Diagram -- Air Impact WrenchFor technical questions, please call 1-800-444-3353.
SPECIFICATIONSRATCHET WRENCH —Average Air Consumption 4 CFMRecommended Air Pressure 90 PSIAir Inlet ¼” NPTFree Speed 150 RPMMaximum Torque (ft. lbs.)
6. USE THE RIGHT TOOL FOR THE JOB. Do not attempt to force a small tool or attachmentto do the work of a larger industrial tool. Do not use a tool for
18. DRAIN COMPRESSOR EVERY DAY. Do not allow moisture to build up inside the compres-sor. Do not allow compressor to sit pressurized for longer than o
GROUNDING INSTRUCTIONSIf compressor has a three-prong plug1. This machine has a three-prong plug. The third prong (round) is the ground. Plug themachi
UNPACKINGWhen unpacking, check to make sure the following parts are included. All sizes listed below areapproximate. If any parts are missing or broke
AirRatchetOPERATIONSetupFrequent, but not excessive, lubrication is required for best performance. Oil added through theairline connection will lubri
Step 2: Attach the socket to the RATCHET ANVIL (#18) as shown in Figure 2.Step 1: Select the appropriate socket for your needs.Air Ratchet OperationFi
Step 1: Check the direction of the drive by pressing the TRIGGER (#4) as shown in Figure 3.LooseningFigure 3 — Operating the Air RatchetStep 2: If
Comments to this Manuals