Central Pneumatic 92037 Operations Instructions download pdf (Page 4)

Page 4SKU 94802 For technical questions, please call 1-800-444-3353

Unpacking

When unpacking, check to make sure the parts listed on page 8 are included. If any parts

are missing or broken, please call Harbor Freight Tools at the number on the cover of this

manual as soon as possible.

For best service you should incorporate an oiler, regulator, and inline lter, as shown in the

diagram above. Hoses, couplers, oilers, regulators, and lters are all available at Harbor

Freight Tools.

1. You will need to prepare a

” air connector (not included) to connect to the Inlet (31)

on the Impact Wrench. First, wrap the

” air connector with pipe thread seal tape

before threading it into the Inlet (31). Connect the

” ID Air Source Hose to a quick

connect coupler (not included), and then to the Impact Wrench.

Note: If you are not using an automatic oiler system, before operation, add a few drops

of Pneumatic Tool Oil to the airline connection. Add a few drops more after each hour

of continual use.

2. Set the air pressure on the regulator to 90 PSI. Do not exceed the recommended

air pressure of 90 PSI.

3. Check the air connection for leaks. Disconnect from the air source.

Operation

Impact

Wrench

Note: Performance of the compressor (if powered by line voltage) may vary

depending on variations in local line voltage. Extension cord usage may also affect

tool performance.

Warning: The warnings, cautions, and instructions discussed in this instruction manual

cannot cover all possible conditions and situations that may occur. It must be under-

stood by the operator that common sense and caution are factors which cannot be

built into this product, but must be supplied by the operator.

1 2 3 4 5 6 7 8

No comments

Central Pneumatic 92037 Operations Instructions Page 4