Central Pneumatic 99959 User Manual download pdf (Page 7)

SKU 99959 For technical questions, please call 1-800-444-3353. Page 7

Note: Air ow, and therefore tool perfor-

mance, can be hindered by under-

sized air supply components.

The air hose must be long enough 3.

to reach the work area with enough

extra length to allow free movement

while working.

Make sure the Sprayer’s Trigger is 4.

in the off position; refer to Operation

section for description of controls.

Close the in-line safety valve be-5.

tween the compressor and the tool.

Turn on the air compressor according 6.

to the manufacturer’s directions and

allow it to build up pressure until it

cycles off.

Adjust the air compressor’s output 7.

regulator so that the air output is

enough to properly power the tool,

but the output will not exceed the

tool’s maximum air pressure (90

PSI) at any time. Adjust the pres-

sure gradually, while checking the air

output gauge to set the right pressure

range.

Inspect the air connections for leaks. 8.

Repair any leaks found.

If the Spray Gun will not be used at 9.

this time, turn off and detach the air

supply, safely discharge any residual

air pressure, and release the Trigger

to prevent accidental operation.

Note: Residual air pressure should not be

present after the tool is disconnected

from the air supply. However, it is a

good safety measure to attempt to

discharge the tool in a safe fashion

after disconnecting to ensure that the

tool is disconnected.

OPERATING INSTRUCTIONS

Read the ENTIRE IMPORTANT

SAFETY INFORMATION

section at the beginning of this

manual including all text under

subheadings therein before set

up or use of this product.

Inspect the Sprayer before use,

looking for damaged, loose,

and missing parts. If any

problems are found, do not use

Sprayer until repaired.

Tool Set Up

TO PREVENT

SERIOUS INJURY

FROM ACCIDENTAL

OPERATION:

Turn off the tool, detach the

air supply, safely discharge

any residual air pressure in

the tool, and release Trigger

before performing any

inspection, maintenance, or

cleaning procedures.

TO PREVENT SERIOUS

INJURY:

Do not adjust or tamper with

any control or component in a

way not specically explained

within this manual. Improper

adjustment can result in

tool failure or other serious

hazards.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments