Central Pneumatic 61693 Owner's Manual download pdf (Page 12)

Page 12 For technical questions, please call 1-888-866-5797. ITEM 61693

SAFETY SETUP OPERATION MAINTENANCE

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

Compressor Area Set Up

1. Designate a work area that is clean and well-lit.

The work area must not allow access by

children or pets to prevent injury.

2. Locate the Compressor on a flat level surface to

ensure proper pump lubrication and to prevent

damage to the unit. Keep at least 12″ of space

around the unit to allow air circulation.

3. Route the power cord from the compressor

to the grounded wall outlet, along a safe path

without creating a tripping hazard or exposing

the power cord to possible damage.

General Operation

1. IMPORTANT: First, turn the Power Switch OFF.

This releases tank pressure and allows the motor

to start freely, without tripping the Circuit Breaker.

2. Close the Drain Valve by turning it clockwise. (See

Draining Moisture from the Tank on page 15.)

3. Check for oil leaks and check the oil level

(See Checking the Oil on page 8).

4. Close the in-line shutoff valve between

the Air Compressor and the air hose.

5. Plug the Power Cord into a grounded

120VAC electrical outlet.

6. Turn the Power Switch ON.

7. Allow the Air Compressor to build

up pressure until it cycles off.

Note: At the beginning of the day’s first use

of the Air Compressor, check for air leaks by

applying soapy water to connections while the

Air Compressor is pumping and after pressure

cut-out. Look for air bubbles. If air bubbles are

present at connections, tighten connections. Do

not use the Air Compressor unless all connections

are air tight - the extra air leaking out will cause the

Compressor to operate too often, increasing wear.

Note: As long as the Power Switch is set to ON,

the Air Compressor’s operation is automatic,

controlled by an internal pressure switch. The Air

Compressor will turn on automatically when the

air pressure drops to 95 PSI, and will turn off

automatically when the air pressure reaches 125 PSI.

WARNING! TO PREVENT SERIOUS

INJURY AND DEATH FROM

EXPLOSION:

Do not adjust the internal

pressure switch. Any change to the

automatic pressure levels may cause excess pressure

to accumulate, causing a hazardous situation.

8. Adjust the Pressure Regulator so that the air

output is enough to properly power the tool, but

the output will not exceed the tool’s maximum

air pressure at any time. Turn the Regulator

clockwise to increase the pressure and counter-

clockwise to decrease pressure. Adjust the

pressure gradually, while checking the Output

Pressure Gauge to set the pressure.

9. Make sure the air tool’s throttle or switch is in the

off position. Connect the air tool to the air hose.

10. Open the in-line shutoff valve.

11. Use the air tool as needed.

12. After the job is complete, turn

the Power Switch OFF.

Note: Turn the switch off before

unplugging the compressor.

13. Unplug the Air Compressor.

14. Close the in-line shutoff valve.

15. Bleed air from the tool then disconnect the tool.

16. Turn the Drain Valve two turns counterclockwise

to release the internal tank pressure and any

built-up moisture. Close the Valve after moisture

has drained out. Do not remove the Drain Valve.

17. Clean, then store the Air Compressor indoors.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Central Pneumatic 61693 Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Air compressors Central Pneumatic 61693